Australian Synchrotron

Session

Session 9 - Manufacturing, Engineering and Cultural Heritage

19 Nov 2020, 14:50

ANSTO

288. Dual sample analysis on the XFM beamline: a new approach to increase the throughput of analysis of large samples

Casey Doolette (University of South Australia)

19/11/2020, 14:50

Manufacturing, Engineering and Cultural Heritage

Oral

Casey L. Doolette1, Daryl L. Howard2, David, J. Paterson2, Cameron M. Kewish2, Nader Afshar2, Peter M. Kopittke3, Enzo Lombi1
1University of South Australia, Future Industries Institute, Mawson Lakes, South Australia 5095, Australia
2Australian Synchrotron, ANSTO Clayton, Victoria, 3168, Australia
3The University of Queensland, School of Agriculture and Food Sciences, St....

215. Fast-scanning X-ray Diffraction Microscopy (SXDM) at the XFM beamline

Dr Michael Jones (QUT)

19/11/2020, 15:20

Manufacturing, Engineering and Cultural Heritage

Oral

Scanning X-ray Diffraction Microscopy (SXDM, aka ptychography) produces phase and absorption contrast images at high spatial resolution, well below the incident beam size(1). The experimental conditions for SXDM are close enough to X-ray Fluorescence Microscopy (XFM) that they are readily combined into a single simultaneous measurement(2-5). However, SXDM has additional coherence and...

221. Trace element distributions in Al-Zn based coating alloys on steel substrates investigated by synchrotron XFM

Dongdong Qu (The University of Queensland)

19/11/2020, 15:40

Manufacturing, Engineering and Cultural Heritage

Oral

The 55Al-Zn-1.6Si alloy is widely used in hot-dip galvanizing to coat steel and displays a multilayered microstructure (steel substrate/intermetallic compound (IMC) layer/coating overlay) that offers protection from corrosion. Trace level (less than a few tens of ppm) V and Cr are hypothesized to influence the corrosion performance of the coated steel via localized segregation. This work...